MatrixPRO-II analog series

Next generation of analog wideband matrix switchers


Základní informace

Barco's MatrixPRO-II series features bandwidth greater than 600 MHz @ -3 dB with  +/- 1.0dB flatness to 300 MHz. This high bandwidth and flat frequency response allows for image switching and signal distribution without artifacts. All models feature a genlock input, ensuring that all switching is synchronized with the house sync. A user-selectable RGB delay mode allows down-stream equipment to lock to a new signal before anything is visible on the screen. Up to 32 presets can be stored for easy system reconfiguration.

Barco's MatrixPRO-II series also features I/O grouping and split mode switching, which allows the matrix to be divided into smaller sub-switchers and each color channel to switch independently. The MatrixPRO-II routers can be controlled from the front panel, RS-232, or Ethernet connections. All models are controllable from Barco's Encore and ScreenPRO-II presentation systems, which results an easy, integrated workflow.

Barco's MatrixPRO-II analog series offers three models of wideband matrix switchers: 12x8, 16x16 and 32x32. All three configurations are available with an audio option and the 12x8 and 16x16 models are also offered with an optional cable equalization feature.


Connector type: female BNC
Bandwidth (fully loaded @0.7Vpp): 600MHz at -3dB
Flatness: +/-1.0dB to 300MHz
Gain: Unity
Impedance: 75 Ohm
Level: .7V nominal, 2V max p-p
RGB output delay: 0.1 to 10 sec

Input level: 0.5V to 5.0V p-p, 4V nominal
Output level: TTL 2.4V into 75 Ohm load
Impedance: 75 Ohms
Polarity: same as input ohms
Cable equalization: available on EQ models

Number of input and outputs: matches video I/O configuration
Type: balanced stereo
Connector: five position pluggable captive screw terminal
Frequency: 20Hz to 20 kHz
HD + noise: .05% at 1kHz at max rated output
Signal/noise ratio: >90 dB
Impedance: 10 kOhm (input) / 50 Ohm (output)
Max level: +22 dBm (input and output)
Input gain switch: 0/+ 14dB switchable per input
Input trim range: +/- 10dB per input
Output volume range: -45 to +5dB per output
Audio test conditions: 1kHz tone @ 0dBm (input) / 600 Ohm load (output)

Input power: 100-230V, 1.3A max

Ke stažení


Hledáte technologického partnera? Neváhejte se na nás obrátit.

šipka nahoru